User Tools

Site Tools


project:member:dormant:pebble

Table of Contents

Pebble

The Pebble is a basic set of sensors and devices that can be used to learn about programming the Arduino.

The basic Pebble design always includes a rotary encoder, a temp sensor, an LDR, an XBee form-factor socket and an LCD screen.

Pebble Version 1 was a shield usable with an Arduino Uno/Duemilanove (or compatible) form factor. This also had a few buttons for feedback.

Pebble Version 2 was an all-in-one device that included an ATmega328P on-board (Uno compatible), included a buck-inverter so that the device could be run off a wide variety of voltages, an RGB Led, and 2 open collector transistor outputs.

In each case the LCD screen is connected to the Pebble, usually by a ribbon cable.

Both versions were designed by Luke Weston.

Version 1

The Version 1 design was predominantly created with through-hole components. It was created for use at the Arduino Mini-Conf at LCA2010.

pebble_all.jpgpebble_7_under_s.jpg

Version 2

The Version 2 design was rebuilt with predominantly surface mount components, with a few through-hole components provided unpopulated. It was created for use for use at the Arduino Mini-Conf at LCA2012.

pebble_v2_with_lcd.jpgpebble_v2.jpg

project/member/dormant/pebble.txt · Last modified: 2015/04/16 20:22 by projectgus